Aerosol Diluter
VDI 2083
VDI 3491
ISO 21501

VDS 562 - Aerosol Dilution System VDS 562

INNOVATION
The Variable Dilution System VDS 562 was especially developed to lower concentration levels of highly concentrated aerosols to adequate concentration levels by one device, without external particle-free air supply and negligible pressure drop. more

The Variable Dilution System VDS 562 was especially developed to lower concentration levels of highly concentrated aerosols to adequate concentration levels by one device, without external particle-free air supply and negligible pressure drop.

For optimal aerosol-analytical conditions, several measurement and test applications require a defined reduction of the particle number concentration (VDI 3491). Depending on the application, dilution factors between > 1 up to 1’000’000 can become necessary. In practise, especially the realisation of high dilution factors (> 1’000) is complicated (e.g.: cascading of dilution systems) and is accompanied either by a considerable pressure drop or by an excessive air consumption. The dilution factor of a VDS 562 can be varied within each operation range over approximately one decade. According to the customer’s requirements, one VDS 562 device can be calibrated for multiple flow rates from 28,3 l/min up to 100 l/min.

less
  • considerable high, infinitely variable dilution by one device (up to 1:100’000)
  • to be calibrated at factory for multiple flow rates between 28,3 l/min – 100 l/min
  • pressure drop compensation by implemented blower (active dilution)
  • controlled set point dilution and possibility of remote-controlled adjustment
  • reduction of high particle concentrations to analytically-suited concentration levels
  • dilution of raw gas concentrations approval/validation of clean rooms (VDI 2083)
  • avoidance of agglomeration (coagulation) in sampling lines for process monitoring
  • validation of optical particle counters for clean room applications (ISO 21501-4)

optional:

  • antistatic silicon tube (∅4,8 mm, ∅ 7,9 mm)

The principle of operation of the VDS 562 is based on the approved dilution principle used by Topas, where the inlet aerosol flow is split at first by a flow resistance (capillary). After particle separation from the bypass, both the capillary flow and bypass flow are consolidated. This results in a reduced concentration at the outlet of the dilution system.

A controlled blower within the bypass compensates pressure drop and serves for automated readjustment of the flow rate to ensure a constant dilution over time.

dilution factor variable, based on type of capillary and operation flow rate (e.g.:6‘000                      … 100‘000)
pressure drop 100 … 400 Pa, depends on dilution range
flow rate several flow stages between 28,3 … 100 l/min, calibration at factory
control response time < 2 min
filter category HEPA
filter capacity 20 g
PC-interface USB
power supply 115 … 230 V AC
dimensions 300 x 200 x 130 mm
weight 2,5 kg